auto

Customised printer produces working OLED display


Researchers in the US have used a customised printer to fully 3D print a flexible organic light-emitting diode (OLED) display.  

According to the team at the University of Minnesota Twin Cities, the advance could result in low-cost OLED displays that could be produced using 3D printers by anyone at home. The research is detailed in Science Advances.

The OLED display technology converts electricity into light using an organic material layer. OLEDs function as high quality digital displays, which can be made flexible and used in large-scale devices and handheld electronics. OLED displays are lightweight, power-efficient, thin and flexible, and offer a wide viewing angle and high contrast ratio.

“OLED displays are usually produced in big, expensive, ultra-clean fabrication facilities,” said Michael McAlpine, a University of Minnesota Kuhrmeyer Family Chair Professor in the Department of Mechanical Engineering and the senior author of the study. “We wanted to see if we could basically condense all of that down and print an OLED display on our table-top 3D printer, which was custom built and costs about the same as a Tesla Model S.”

MORE FROM ELECTRONICS & COMMUNICATIONS

The group had previously tried 3D printing OLED displays, but they struggled with the uniformity of the light-emitting layers. Other groups partially printed displays but also relied on spin-coating or thermal evaporation to deposit certain components and create functional devices.

In this new study, the University of Minnesota research team combined two different modes of printing to print the six device layers that resulted in a fully 3D-printed, flexible organic light-emitting diode display. The electrodes, interconnects, insulation, and encapsulation were all extrusion printed, while the active layers were spray printed using the same 3D printer at room temperature. The display prototype was about 1.5 inches on each side and had 64 pixels that worked and displayed light.

OLED display
Fully 3D-printed flexible organic light-emitting diode (OLED) display prototype (Image: McAlpine Group, University of Minnesota)

“I thought I would get something, but maybe not a fully working display,” said Ruitao Su, the first author of the study and postdoctoral researcher at MIT. “But then it turns out all the pixels were working, and I can display the text I designed. My first reaction was ‘It is real!’ I was not able to sleep, the whole night.”

Su said the 3D-printed display was also flexible and could be packaged in an encapsulating material, which could make it useful for a wide variety of applications.

“The device exhibited a relatively stable emission over the 2,000 bending cycles, suggesting that fully 3D printed OLEDs can potentially be used for important applications in soft electronics and wearable devices,” Su said.

The researchers said the next steps are to 3D print OLED displays that are higher resolution with improved brightness.

“The nice part about our research is that the manufacturing is all built in, so we’re not talking 20 years out with some ‘pie in the sky’ vision,” McAlpine said. “This is something that we actually manufactured in the lab, and it is not hard to imagine that you could translate this to printing all kinds of displays ourselves at home or on the go within just a few years, on a small portable printer.”



READ SOURCE

Leave a Reply

This website uses cookies. By continuing to use this site, you accept our use of cookies.  Learn more